Product catalog
Products
5 product(s) in Printing Additives
Printing Additives
Specialized additives for improved adhesion, rub resistance, slip, pH stability, and foam control, supporting consistent ink performance and print quality.

Adhesion Promoters
Adhesion promoters help ink hold on films and other surfaces that resist ordinary binders, especially polyethylene, polypropylene, and some coated boards. Without them a print can look correct and still fail a tape test or peel in the laminate. PACKINK adhesion promoters go into the ink the way the formula specifies, not as a random press-side pour. They are for solvent and water-based packaging inks where the substrate, not the color, is the problem. Match the promoter to the ink system before it enters a finished batch.

Rub Resistance Additives
Rub resistance additives make a dried ink film harder to scuff, scratch, or smear when packs rub in transit, on a filling line, or in a stack. They are used when the color is right but the surface marks too easily. PACKINK rub additives are blended in at the dosage the formula allows. More is not always better: too much can dull gloss or affect adhesion and sealing. They suit cartons, labels, and flexible packs that must stay clean after handling.

Slip And Wax Additives
Slip and wax additives change the surface of a dried ink or varnish. Wax improves scratch resistance and can reduce blocking; slip additives lower friction so sheets and webs move without grabbing. PACKINK supplies them for packaging inks that must slide, stack, or resist scuffing. The type and the amount depend on whether the next step is lamination, heat sealing, or simple stacking. Too much slip can hurt adhesion or seal strength, so follow the formula.

pH Adjusters And Stabilizers
pH adjusters and stabilizers keep water-based inks in the alkaline range they were built for. As amine leaves an open or circulating ink, pH falls, viscosity rises, and the ink can thicken, dry in the anilox, or lose stability. PACKINK pH products are added in small measured doses and checked with a meter, not by eye. They support consistent water-based print on flexo and related presses. They are not a thinner: if the ink is thick only because water has left, correct viscosity and pH separately.

Antifoams
Antifoams stop bubbles building up in water-based inks, coatings, and circulation tanks. Foam looks harmless in the pail, but on a flexo or gravure press it causes pinholes, uneven laydown, and pumps that lose their prime. PACKINK antifoams are added in small amounts while the ink is made up or while it circulates. Use only what the formula needs: enough to knock the foam down, not so much that the additive marks the print or fights a wax or slip additive.
Need a specific grade?
Tell us your press, substrate, and volume — we'll point you to the right line.